If a motor stops at 2 a.m. and the drive is flashing an Err code, you do not need a sales brochure — you need the cause and the fix. This center collects the technical information we use every day on our own production and test line, organized so you can find the answer in under a minute.

Browse by what you are working on

Faults, wiring & setup

Communication & advanced control

Brand alternatives

The three problems that cause most VFD downtime

In our workshop, almost every commissioning problem falls into one of three groups. Start here:

• Fault & alarm codes — the drive is telling you exactly what is wrong; you just need the code table (Err01–Err71).
• Wiring — swapped input/output terminals, a missing ground, or wrong Sink/Source jumper are the usual suspects.
• Parameters & tuning — vector control without motor auto-tuning is the #1 cause of nuisance overcurrent trips.

From our test bench, not generic AI text

Every 300N drive — from the 0.75 kW single-phase unit to the 800 kW cabinet — goes through full-load and insulation testing on our own line before it ships. The fault tables, terminal definitions and tuning procedures below are the same ones our engineers follow. That first-hand data is what lets this content give you a real answer instead of a generic definition.

Need the manual or wiring diagram? Download documents from our VFD download center.